Charge for 16 hours before use.        The Battery symbol will appear, but the bars inside

                                      do not fill up.  

Press Green to make a call and Green to hang up

The answer machine will only work when the base is on, lamp red.

 

ANSWER MACHINE:

Press   TAPE (top right)   Any messages received will be played

 

To Record your message press 4 then 5, dictate

                                "I'm not here right now so please leave a message

                                 after the tone" then press 8

To listen to your out going message press 5

 

To delete a message press 6 (X) during playback

To Play messages press 2   to skip forward 3 and to skip back 1

 

To activate the answer machine before you go out press 9 (on)                Base lights red

To turn answer machine off when you are at home press 7 (off)                Base lights green

 

Press TAPE to finish using the answer machine.

 

Setting the time and day;       Press R ^^^ (ANSW SETUP) OK, ^ (DAY TIME) OK, Use ^ to

Select the Day then OK, Select the Hour OK, Select the Minute OK Then R to exit.

 

PHONE BOOK

Press R (phone book appears) then OK

Use ^ v to select store or remove as required, then press OK

Enter phone number using then OK enter name (BOB   will be 22 666 22) then OK

 

Caller ID

To view numbers held in the caller log press the very bottom button.  

To remove numbers keep pressing OK.

Handset name;   R ^ ^ (Setup) OK ^^ (Base Name) OK Then Enter name using keypad. OK

Registering  a handset;  Press R press ^ till "setup", press Ok, press ^ till "register", Ok, "code?" will appear,

                                    Enter the 4 digit number underneath the base, Ok. 

 

Pin Code. This is underneath the base. If you have changed it and don't know it then you may need to buy a new base. However, some customers have reported: "I found out pressing the OK button with phone on station (with power cable removed), the phone-display disappears - now plugging in the power cable while still holding the OK button resets the station to the code underneath the base"